Assembly for Prochem Heater Core (Copper)
Kohler Ageis pre-air filter.
Stainless steel chemical pump by General Pumps.
Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
Throttle Cable Peak
This recovery tank level kill switch can also be used as the pump-out activation switch. This switch fits most BLUEline and some HydraMaster units.
Belt for the vacuum pump on the Bruin, Peak and the water pump on the Everest 408/650, BLUEline Champ and BlueWave.
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.
This voltage regulator fits the Kohler engines on the Prochem Legend series and the BLUEline Champ truck mounts
Gates belt used for the alternator on the Prochem Apex, Bruin II and gas engine BLUEline BlueWave truck mounts.
This check valve fits most Prochem stainless steel chemical pumps.
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
Diaphragm for chemical pump used on all Prochem truck mounts and on all non-HP BLUEline truck mounts.
Cat Pumps 5CP2150WCS.3
Round hour meter used on ALL Prochem and BLUEline truck mounts.
20-amp, 12-volt circuit breaker is easy to install and resettable.
Ignition switch with key.