Prochem Legend GT Truck Mount Replacement Parts
-
Valve Float AssemblyValve assembly for the water box on all Prochem truck mounts.
- Valve
- Water box
$104.50 -
Cat Pumps Pressure Regulator (7670.100)
Pressure regulator works on most Prochem and BLUEline machines.
$133.98 -
Valve, Chemical Metering
This 1/8" female pipe thread chemical metering valve will fit most Prochem, BLUEline, Sapphire Scientific and HydraMaster units.
- SwageLok Valve
- Needle Valve
- 1/8"
-
Fuel Filter Kohler
Kohler Fuel Filter
- 51 Micron
- 1/4" fuel line
Â
-
Kohler Oil Filter
Oil Filter for Legend truck mounts.
- Dimensions.: 3" W x 2.6" L
- Spin-on design
- Genuine Kohler part
- For use with Legend truck mounts
-
Filter, Pre‑Air Kohler
This pre-air filter has been manufactured to fit the following Kohler Command engine-equipped truck mount units: Prochem Legend, Legend SE and Legend XL.
- Pre-filter
Â
-
Carburetor, 20 HPCarburetor - 20 HP - Kohler #2485332-S$347.12
-
Truck Mount Pump Out System
Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
- 0.5HP drive motor
- Diaphragm pump by COMET USA
- For use with any truck mount system
$2,263.57 -
Starter Kohler
Kohler Starter
- Spin-on design
- Genuine Kohler part
$234.48 -
Kohler PTO Rear Oil Seal (52 032 08‑S)ea Kohler Oil Seal PTO Rear oil seal
-
Chemical Pump Check Valve (42‑809265)
This check valve fits most Prochem stainless steel chemical pumps.
- Check Valve
- For Use with Many Prochem and HydraMaster Chemical Pumps
- Ships Same Day
-
Chemical Pump Disk (36‑003)
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
- Chemical Pump Disk
- For Round Style Last Step Chemical Injection
-
Chemical Pump Diaphragm
Diaphragm for chemical pump used on all Prochem truck mounts and on all non-HP BLUEline truck mounts.
- Rubber diaphragm
- For use with Prochem and BLUEline truck mounts
- For use with select newer Hydramaster units
-
12V Fuel Pump (035000‑0510)
Electric 12 VDC fuel pump.
- Fuel pump
- 12 volt
- 2-3 psi
-
Sensor, Temperature GaugeTemperature gauge sensor.
- Variable Temperature Sensor
- For Use with Various Styles of Truckmount
- Free Technical Support
-
Circuit Breaker, 20A
20-amp, 12-volt circuit breaker is easy to install and resettable.
- Circuit Breaker
- 20A
- Resettable
- 30-008
-
Ignition Switch with Key
Ignition switch with key.
- Switch, ignition
-
Lubrication Cup
Lubrication Cup
- Cup, lubrication
-
Dwyer Instruments FlowMeter (VFA‑42)
2-10 GPH flow meter fits most truck mounts in the industry.
- Meter, flow
-
Vacuum Gauge (26‑004)2-1/2" panel mount gauge 0-30"HG
- Vacuum Gauge
- 0-30"HG
- White Face
-
Gauge, Water Pressure
1500 PSI Water Pressure Gauge.
- 2-1/2" Panel MountÂ
- 0-1500PSIÂ
- White Face
-
Hour Meter
Round hour meter used on ALL Prochem and BLUEline truck mounts.
- Hour meter
$158.99 -
Valve, Bypass
Valve - Met 1/8-inch F x F 90-degree ball valve.
- Valve, heat bypass
-
Flojet Transfer Pump (4325‑143)
Flojet on-demand pump used for transfer system will mount on a blue pressure tank. Model 4325-143.
- 12 VDC 4.5 GPM
- 40 psi
$203.56
