Items 1-24 of 47
Assembly for Prochem Heater Core (Copper)
Stainless steel chemical pump by General Pumps.
Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
This recovery tank level kill switch can also be used as the pump-out activation switch. This switch fits most BLUEline and some HydraMaster units.
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.
This check valve fits most Prochem stainless steel chemical pumps.
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
Diaphragm for chemical pump used on all Prochem truck mounts and on all non-HP BLUEline truck mounts.
Round hour meter used on ALL Prochem and BLUEline truck mounts.
20-amp, 12-volt circuit breaker is easy to install and resettable.
Engine ignition switch with key for older large Prochem truck mounts and BLUEline truck mounts.
2-10 GPH flow meter fits most truck mounts in the industry.
Valve assembly for the water box on all Prochem truck mounts.
Valve - Met 1/8-inch F x F 90-degree ball valve.
This 1/8" female pipe thread chemical metering valve will fit most Prochem, BLUEline, Sapphire Scientific and HydraMaster units.
Outlet Check Valve Assembly used on all Prochem, BLUEline and Sapphire Scientific models.
1 1/2" Ball Dump Valve fits nearly all truck mounts in the industry.
Filter by: (0)