Items 1-24 of 62
General Pump 180° thermal relief valve.
Stainless steel chemical pump by General Pumps.
Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
This recovery tank level kill switch can also be used as the pump-out activation switch. This switch fits most BLUEline and some HydraMaster units.
This O-ring goes on the check valve cap and seals the cap to the check valve. Measures 7/8" ID x 1 1/16" OD.
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.
This voltage regulator fits the Kohler engines on the Prochem Legend series and the BLUEline Champ truck mounts
Prochem Fuel Filter for Kubota Engines
This pre-air filter has been manufactured to fit the following Kohler Command engine-equipped truck mount units: Prochem Legend, Legend SE and Legend XL.
Kohler Fuel Filter
Oil Filter for Legend truck mounts.
This check valve fits most Prochem stainless steel chemical pumps.
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
Electric 12 VDC fuel pump.
This temperature sensor shuts unit off when solution temperature reaches 285 degrees, and won't allow the unit to start until the temperature has gone down.
Round hour meter used on ALL Prochem and BLUEline truck mounts.
20-amp, 12-volt circuit breaker is easy to install and resettable.
Filter by: (0)