Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
This 1/8" female pipe thread chemical metering valve will fit most Prochem, BLUEline, Sapphire Scientific and HydraMaster units.
Stainless steel chemical pump by General Pumps.
Low pressure sensor.
Prochem Fuel Filter for Kubota Engines
Â
Spark Plug, 3 required, gap at .039
Gates belt used for the alternator on the Prochem Apex, Bruin II and gas engine BLUEline BlueWave truck mounts.
Â
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.
This O-ring goes on the check valve cap and seals the cap to the check valve. Measures 7/8" ID x 1 1/16" OD.
Â
Belt for the vacuum pump on the Bruin, Peak and the water pump on the Everest 408/650, BLUEline Champ and BlueWave.
Choke Cable
This recovery tank level kill switch can also be used as the pump-out activation switch. This switch fits most BLUEline and some HydraMaster units.
This check valve fits most Prochem stainless steel chemical pumps.
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
Pressure regulator works on most Prochem and BLUEline machines.
High pressure sensor.
Engine ignition switch with key for older large Prochem truck mounts and BLUEline truck mounts.
20-amp, 12-volt circuit breaker is easy to install and resettable.
Round hour meter used on ALL Prochem and BLUEline truck mounts.