Sapphire Scientific 870 Truck Mount Replacement Parts

Heavy duty flower thumb knob.

30A 12V Circuit breaker.

20-amp, 12-volt circuit breaker is easy to install and resettable.

Temperature gauge sensor.

This O-ring fits on the seat for the check valve for most Prochem truck mounts.

This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.

This O-ring goes on the check valve cap and seals the cap to the check valve. Measures 7/8" ID x 1 1/16" OD.

Prochem Bypass Manifold Orifice for Bruin and Performer (green).

Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.

1992-98 Ford E Series fuel tap kit.

Complete 11 Piece Kit

Poppet - Check Valve Assembly

Brass bypass manifold filter screen.

1.5" Female Vacuum Rubber Plug that fits most male barb and straight pipe inlets.

Control Temp 275 Degrees.

Stainless steel truckmount waste tank filter basket.

Neoprene gasket

This vacuum hose connector easily joins 2 x 2-inch vacuum hoses. Constructed of high-tension plastic, this hose cuff holds tight, no matter how much pressure it receives.

2-inch hose to a 1-1/2 inch male pipe thread.

1/2"F Nylon in-line water filter.

Y Strainer used on all Prochem truck mounts.

This is a 3/8" brass female quick connector with 3/8" female threads. Works with most water inlets on truck mounts.

1/8"MPT x 5/16"H brass hose barb.

This check valve fits most Prochem stainless steel chemical pumps.