Prospector 150 w/Heat Portable Extractor Replacement Parts

Float/filter assembly for the Prospector Series portable extractors.

Caster, 3-1/2", non marking wheel.

10" x 1-3/4" rear non-marking wheel.

The most common female quick disconnect for the carpet cleaning industry. The 1/4", brass, female coupler is equipped with double EPDM seals which are resistant to high pressure, high temperature, all but solvent based chemicals and abrasion.

2 Stage Vacuum Blower for dual vacuum units. Unit has 5.58” diameter motor with 80” of water lift. This fits many Ninja Deluxe units after serial #C14855 and Ninja Deluxe units with heat after serial #PH2094 and other units containing dual 2 stage motors.

Hose Barb  1.5 MPT x 1.5H

Strain Relief 12 Gauge made from heavy duty plastic.

115V 1.3GPM 170 PSI ShurFlo pump with Viton check valves. Pump is equipped with 125 PSI demand switch which allows it to be used with low flow rate tools such as upholstery and stair tools. This pump can be used in nearly any application where a 100 PSI pump is currently used.

This replacement 120 PSI pump draws 115VAC and delivers a flow rate of 1.4 GPM. This self-priming pump can withstand a maximum temperature of 170°F and is capable of running dry.

25' Extension Cord

ea Heat Sensor for Xtrctr

Corded pigtail wire.

Prospector hatch and ring assembly

Rocker switch for portables, single throw, rated at 125V, 16 amps. Lighted switch comes with plastic splash guard.

This gasket fits the 5-5/8" vacuum motors.

1-1/2" Drain Valve including the spout and gasket.

This Flow Control K-Valve is rated at pressures up to 500 PSI. This part is easily rebuildable.

Mushroom shaped stainless steel filter for solution tank.