Fiberlock IAQ 6000 Mold Resistant Coating is an extremely durable coating developed to withstand moist, humid conditions that are ideal for mold growth.
This easy to apply, 100% acrylic coating offers the ultimate in durability in combination with excellent mold resistance.
Fiberlock IAQ 6000 does not contain any compounds with toxic metals, such as barium, boron, or zinc, which are present in other mold-resistant coatings.
IAQ 6000 contains an EPA-registered, broad-spectrum fungicide to prevent the growth of mold on the surface of the cured film. Additionally, its smooth finish minimizes dirt buildup that provides nutrients for mold growth.
Recommended for use on:
Apply Fiberlock IAQ 6000 with brush, roller, or airless spray equipment. Refer to the product application section below for more specific information on settings and which tools to select.
Air and surface temperature must be 50°F or above during application and drying period. Fiberlock IAQ 6000 is supplied ready to use, but can be thinned sparingly with water (up to 1/2 pint water per gallon) for proper application consistency if necessary. Apply Fiberlock IAQ 6000 generously and uniformly by brush, roller or airless sprayer. Ensure that the finished surface is properly sealed.
Stir thoroughly. Do not mix with any other coatings, solvents, or colors in oil. Fiberlock IAQ 6000 is resistant to the deteriorating action of mold, mildew, and bacteria. No claim is made for the preservative action to other than the coating film. Do not apply when air or surface temperature is below 50°F or when drying conditions are poor. Keep from freezing. Use adequate ventilation during application.
Clean tools and drippings with warm, soapy water before Fiberlock IAQ 6000 dries. Dispose of all waste according to all existing local, state, and federal regulations.
• Solids by Weight ± 2%: 54.6%
• Solids by Volume ± 2%: 39.6%
• Viscosity at 70°F: 90-95 Kreb Units
• Specular Gloss: 6º ± 1 @ 60º
• Flash Point: Non-combustible
• Odor: Virtually odorless
• Shelf Life: at 70°F, 36 months minimum (in original factory sealed containers)
• Calculated VOC: 75 grams/liter
• Smooth surfaces: 250-400 ft2/gal
• Porous Surfaces: 150-300 ft2/gal
Drying Times (@ 70 - 77°F , 50% R.H.):
• To touch: 1 hour
• To recoat: 4 hours
• Water Vapor Permeance: 3.7 perms
• IAQ 6000 may be tinted to any off-white or pastel based color. Add up to 2 oz of universal colorant per gallon.
|Prop 65 Text||This product can expose you to chemicals including Titanium dioxide and Chlorothalonil which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.|
|Approved Use||Mold Remediation|
|Max Coverage Per Gallon||400|
|Manufacturer Model Number||8360-5|
|Xactimate Code||PNT S+++ - Seal the walls and ceiling with an antimicrobial coating - One coat|