Prochem Performer 405 Truck Mount Replacement Parts
This blower fits the Performer 405 units.$2,191.55
Main stainless steel tube style heat exchanger fits Prochem Legend and Performer models. This part is sold as the coil and shell with mounting feet.
- Replacement coil mount and casing
- Does not include covers or shields
Flojet on-demand pump used for transfer system will mount on a blue pressure tank. Model 4325-143.
- 12 VDC 4.5 GPM
- 40 psi
SHURflo transfer pump. 12V right to left flow used on the older style water transfer systems on Prochem truck mounts. Typically used a square D pressure switch and was mounted next to or on top of a gray tank in a gray metal box. Pump comes with wing nut barbs for hose.
- 12 DC pump
- Does not include pressure switch
- 3.3 GPM
- 40 PSI max
Featuring a 12VDC motor this diaphragm waste pumpout produces consistent, smooth pulsation to prevent misdirected wastewater flooding. This pump can be run dry for short periods without causing damage to the pump.
- 0.5HP drive motor
- Diaphragm pump by COMET USA
- For use with any truck mount system
2-1/2" panel mount gauge 0-30"HG
- Vacuum Gauge
- White Face
1500 PSI Water Pressure Gauge.
- 2-1/2" Panel Mount
- White Face
Water Temp Gauge
- Gauge, water temp
2-10 GPH flow meter fits most truck mounts in the industry.
- Meter, flow
Cat Pump brand 5CP plunger pump, pumps 4.5GPM with a max pressure of 3,500PSI. Clutch and belt driven with 3/8" FPT ports.$1,100.00
Cat Pumps 5CP2150WCS.3
- Cat Pumps
- 5.0 gpm
- 2200 PSI 5.0GPM
- 20MM Right Side Shaft
Electric 12 VDC fuel pump.
- Fuel pump
- 12 volt
- 2-3 psi
Stainless steel chemical pump by General Pumps.
- Stainless Steel
- Easily Rebuildable
- Used On A Wide Variety Of Truck Mount Systems
Diaphragm for chemical pump used on all Prochem truck mounts and on all non-HP BLUEline truck mounts.
- Rubber diaphragm
- For use with Prochem and BLUEline truck mounts
- For use with select newer Hydramaster units
Stainless steel truckmount waste tank filter basket.
- Stainless Steel
- 12" x 7.5" x 8"
- Filter Basket
1 1/2" Ball Dump Valve fits nearly all truck mounts in the industry.
- Valve, waste systems
This 1/8" female pipe thread chemical metering valve will fit most Prochem, BLUEline, Sapphire Scientific and HydraMaster units.
- SwageLok Valve
- Needle Valve
This temperature sensor shuts unit off when solution temperature reaches 285 degrees, and won't allow the unit to start until the temperature has gone down.
- Sensor, temperature
- Nissan A/15
- Carburetor Solenoid
- For Use with Prochem 405 Units
Nissan governor for model A-15 engine.
- Original governor for the Nissan A12 and A15 engines equipped with a carburetor.
Rotor for Nissan engine A12/A15 with electronic ignition.
- Replacement rotor for Nissan A-12 and A-15 engines
Governor belt for Everest and Performers and water pump for Legend series.
- AX29 Belt
- Fits Governor on Performer after 12/99, Bear and Bear Cat Machine
- Water pump on some Legend units
- Magneto on oil fired truck mounts
- 13 Lb Radiator cap
- Fits some Prochem and BLUEline truck mounts
Face Panel PF405
- Aluminum top panel for Prochem 405