Germs, dirt, odor—none of it stands a chance against Scrubbing Bubbles Disinfectant Bathroom Cleaner. Its tough formula kills 99.9% of common viruses and bacteria, plus it cuts through tough grease, dirt, and grime leaving surfaces clean and bright.
Scrubbing Bubbles kills common germs, including the following:
The convenient spray can works at any angle, allowing you to spray Scrubbing Bubbles on any hard-to-reach surface. The clinging foam stays on the surface, ensuring plenty of dwell time for the product to get to work removing dirt, grease, hard water spots, soap scum, mold, and mildew, so you can easily rinse it all away.
This commercial formula is ideal for use in high-traffic restrooms. It can be used to clean tubs, shower walls and doors, sinks, basins, urinals, countertops, tile, fixtures, and more.
Though it's tough on dirt, germs, and odors, Scrubbing Bubbles is gentle on all water-washable hard surfaces. It won't scratch or etch glazed ceramic tile, stainless steel, chrome, fixtures, fiberglass, or glazed porcelain surfaces.
All your restroom surfaces are left with a clean, brilliant shine!
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.
Shake well before use.
Hold product farther from surfaces than you normally would to get the full benefit of the product's spray pattern. Spray 6–8 inches from the surface to be cleaned. Product can be sprayed from any angle. Wait to allow foam to penetrate dirt and soap scum. Rinse clean or wipe away foam with cloth or sponge. Wipe dry after rinsing, if desired. On chrome, rinse with water.
TO DISINFECT AND DEODORIZE HARD, NON-POROUS SURFACES:
Pre-clean heavily soiled areas. Spray 6–8 inches from hard, non-porous surfaces until thoroughly wet. Let stand for 5 minutes. Then wipe. Rinse food contact surfaces with clean water.
TO SANITIZE AND DEODORIZE HARD, NON-POROUS SURFACES:
Pre-clean heavily soiled areas. Spray 6–8 inches from hard, non-porous surfaces until thoroughly wet. Let stand for 30 minutes. Wipe with a wet cloth or sponge, then rinse thoroughly with water.
TO INHIBIT AND PREVENT THE GROWTH OF MOLD AND MILDEW:
Remove gross filth or heavy soil prior to applying the product for treatment against mold and mildew. On hard non-porous surfaces, spray surface until thoroughly wet. Re-apply as needed.
|Chemical Type||Water Based|
|Material||Chrome, Porcelain, Stainless Steel|
|Category||Aerosol, Deodorizers, Disinfectants, Multi-use Restroom Cleaners|
|Manufacturer Model Number||94308|