Items 49-58 of 58
The green medium-duty brush is used for general-purpose scrubbing on hard surface floors. This brush features 0.012" nylon bristles.
This gentle scrub brush fits the Oreck Orbiter and allows you to clean any floor that could be easily scratched or damaged by traditional stiff-bristled brushes. It features natural fibers that scrub away dirt, scuff marks, wear tracks, and other stubborn soiling without damaging the floor.
Tackle greasy, slippery floors and clean out gunky grout lines with this medium-duty scrub brush designed to fit the Oreck Commercial Orbiter. It's ideal for use in restaurants, kitchens, and other food service/prep areas.
Dig out the dirt and get your floors clean with this heavy-duty scrub brush for the Oreck Orbiter. This brush features stiff bristles that can be used wet or dry to scrub away the grime on scratch-resistant, high-traffic floors to make them look like new again.
To tackle heavy-duty scrubbing and stripping jobs with your Oreck Orbiter, choose the Nylo Grit Scrub Brush. This ultra stiff brush is slightly more aggressive than the orange brush and features imbedded particles in the bristles for added scrubbing power.
Specially designed to offer exceptional cleaning performance on hard floors, these brush heads allow you to boost the revenue-generating potential of your Rotovac Powerwand. Easily clean tile, grout, and vinyl by swapping out the brush heads in as little as 20 seconds.
Clutch plates are available for all rotary brushes sold by Jon-Don plus other brushes with 5-inch center hole. NOTE: Old clutch plates may not fit our brushes. Since most brushes are sold without clutch plates, please be sure you are requesting the correct clutch plate for your machine when ordering.
Clutch plates will fit all rotary brushes sold by Jon-Don, all Hild and Republic brushes, as well as any brush with a 5” center hole. Old clutch plates will normally NOT fit our brushes! All brushes are sold without clutch plates. Please specify when ordering.
Do you occasionally need a brush that is larger than the one that fits your rig? Forget pricey accessories! This 6-3/4-inch plastic riser (with 5-inch center hole) is 1 1/2 inches high and allows you to drop the brush below the lip or rim to do the job.