The HP-PLUS Floor Drying Package is the improved version of Injectidry's HP60i Floor Drying package. This unit is quieter (less than 60 dB), more powerful, and easier to set up than the original. You can use up to 12 Multi-Port or 20 8-Port Vac-It panels with an increase up to 30% in drying capabilities.
The Injectidry HP60 Floor Drying Package is designed specifically for floor drying. This setup is extremely quick, easy, and efficient for your typical floor drying needs.
The HP-PLUS Wall and Ceiling Drying Package is the improved version of Injectidry's HP60i wall and ceiling package. This unit is quieter (less than 60 dB), more powerful, and easier to set up than the original.
Injectidry's high-pressure drying systems are specifically developed to target high risk areas of hidden moisture. The HP60i can be used with Vac-It Panels to quickly dry hardwood floors. Capable of drying over 100 linear feet of wall or ceilings.
The Direct-It “IN” Universal Air Mover Adapter gives you the ability to dry critically damaged areas fast! This handy accessory attaches to most standard centrifugal air movers, and allows you to direct air in as many as 17 different locations and dry up to 22 feet!
The Direct-It Axial Adapter connects to both axial fans and air scrubbers, allowing contractors to direct drying and scrubbing efforts into wall cavities and other areas in need of high air exchange rates. This easy-to-setup system gives you the ability to replace fewer walls, ceilings, and hardwoods.
The Adaptidry achieves high efficiency by dispersing intense drying power simultaneously to multiple areas around the room.
Injectidry Infrared Heating Panels allow restoration professionals to dry areas faster while using significantly less energy. Each panel is designed to directly heat ONLY the wet surface, resulting in dramatically more efficient drying using only 400 watts of energy (roughly 25% of a typical hair dryer!).
HP60 Plus base unit with air out and air in main hoses
The Water Separator works to protect your HP 60 blower by preventing bulk water from passing through it when drying in a negative mode.
The Silencer is made of ABS plastic and quiets the drying system by about 25%. It reduces some of the impeller noise in addition to the air rush sound. Attaches to the 2-inch OUT trunkline and sets up in seconds.
Injectidry's Inline HEPA filtering system stops dirt and debris before it contaminates your equipment and the air.
Package of 100 replacement wall injectors used on Injectidry HP60 and HP60-Plus Units.
If you're tired of having Vac-Panels laying all over the place, then this heavy duty nylon carry bag is for you. Capable of carrying 10 Vac-It Panels.