Blueline ThermalWave HP Replacement Parts
The Gates BX-53 Tri-Power Belt fits the BLUEline Thermal Wave 5M & HP.
- BX section
- BX-53 size
- 21/32" W x 13/32" H
- 56" outside circumference
Brass bypass manifold body only. For older Prochem and BLUEline truck mounts.
- Brass bypass manifold
- Fits most older Prochem and Blueline truck mounts
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.$1.09
Gasket for catalytic heat exchange system on the older Prochem and BLUEline truck mounts.
- Silver high temp gasket for catalytic heat exchangers
Nissan engine thermostat gasket for model A-15 engines.
- Paper thermostat gasket for Nissan A12 engine
Prochem Fuel Filter for Kubota Engines
- Fuel filter for carbureted units
- Filter mounts under van before fuel pump
- Will not work with diesel or fuel-injected engines
KBT Bottle Overflow
- Fits Prochem Performer and Bruin
- Fits Blueline Thermalwave SM and Bluewave truck mounts
Rotor for Nissan engine A12/A15 with electronic ignition.
- Replacement rotor for Nissan A-12 and A-15 engines
Nissan spark plug for model A-12 and A-15 engine. 4 required.
- Spark plug
This oil filter fits the Nissan A-12 and A-15 engines. This filter should be changed very 100 hours. This filter's color/appearance may vary slightly from the photograph, however, it is still compatible with Nissan A-12 and A-15 engines.$13.90
Nissan PCV valve for the model A -12 and A-15 engine.
- Valve, PCV
Nissan valve cover gasket for model A-15 engine.
- Gasket, Valve cover
- For use with Nissan engines
This check valve fits most Prochem stainless steel chemical pumps.
- Check Valve
- For Use with Many Prochem and HydraMaster Chemical Pumps
- Ships Same Day
This temperature sensor shuts unit off when solution temperature reaches 285 degrees, and won't allow the unit to start until the temperature has gone down.
- Sensor, temperature
Thermostat for older Prochem truck mounts and some BLUEline truck mounts.
Temperature gauge sensor.
- Variable Temperature Sensor
- For Use with Various Styles of Truckmount
- Free Technical Support
Round hour meter used on ALL Prochem and BLUEline truck mounts.
- Hour meter
20-amp, 12-volt circuit breaker is easy to install and resettable.
- Circuit Breaker
Prochem Bypass Orifice (Blue - 0.0292) . This is used on the Prochem Legends and Prochem 405 units with Micro-Processors Catalytic and with Auto Diverter Systems.
- Stainless steel bypass orifice
- Blue - 0.0292
Bypass Manifold Cap
- Cap fits orifice side of bypass manifold
This recovery tank level kill switch can also be used as the pump-out activation switch. This switch fits most BLUEline and some HydraMaster units.
- 1 1/2" pipe thread
- BlueLine Equipment
- Sapphire Scientific
3.5" Diameter high temperature hose sold by the foot.
- Sold per linear foot
- High Temperature
- Silicone Impregnated
- Supported With a Steel Wire Helix
ThermalWave and BlueWave submount exhaust kits.
- Submount Exhaust Kit
- For Use with ThermalWave and BlueWave