Blueline ThermalWave 5M Replacement Parts
30A 12V Circuit breaker.
- Circuit Breaker
Nissan spark plug for model A-12 and A-15 engine. 4 required.
- Spark plug
Nissan distributor cap for the model A-12 A-15 engine.
- Replacement cap for distributor
- Fits Nissan A-12 and A-15 engines
Rotor for Nissan engine A12/A15 with electronic ignition.
- Replacement rotor for Nissan A-12 and A-15 engines
KBT Bottle Overflow
- Fits Prochem Performer and Bruin
- Fits Blueline Thermalwave SM and Bluewave truck mounts
Prochem Fuel Filter for Kubota Engines
- Fuel filter for carbureted units
- Filter mounts under van before fuel pump
- Will not work with diesel or fuel-injected engines
Nissan engine thermostat gasket for model A-15 engines.
- Paper thermostat gasket for Nissan A12 engine
Gasket for catalytic heat exchange system on the older Prochem and BLUEline truck mounts.
- Silver high temp gasket for catalytic heat exchangers
This O-ring is .676 Id x .816 Od. It fits the Y-Strainer for the solution outlet assembly and the bypass manifold assembly for most Prochem and BLUEline units.$1.07
This oil filter fits the Nissan A-12 and A-15 engines. This filter should be changed very 100 hours. This filter's color/appearance may vary slightly from the photograph, however, it is still compatible with Nissan A-12 and A-15 engines.$13.63
Nissan PCV valve for the model A -12 and A-15 engine.
- Valve, PCV
Nissan valve cover gasket for model A-15 engine.
- Gasket, Valve cover
- For use with Nissan engines
20-amp, 12-volt circuit breaker is easy to install and resettable.
- Circuit Breaker
Round hour meter used on ALL Prochem and BLUEline truck mounts.
- Hour meter
Temperature gauge sensor.
- Variable Temperature Sensor
- For Use with Various Styles of Truckmount
- Free Technical Support
Thermostat for older Prochem truck mounts and some BLUEline truck mounts.
This temperature sensor shuts unit off when solution temperature reaches 285 degrees, and won't allow the unit to start until the temperature has gone down.
- Sensor, temperature
Diaphragm for chemical pump used on all Prochem truck mounts and on all non-HP BLUEline truck mounts.
- Rubber diaphragm
- For use with Prochem and BLUEline truck mounts
- For use with select newer Hydramaster units
This plastic chemical pump disk works as a diffuser to cushion the diaphragm providing longer life to the diaphragm.
- Chemical Pump Disk
- For Round Style Last Step Chemical Injection
This check valve fits most Prochem stainless steel chemical pumps.
- Check Valve
- For Use with Many Prochem and HydraMaster Chemical Pumps
- Ships Same Day
This O-ring goes on the check valve cap and seals the cap to the check valve. Measures 7/8" ID x 1 1/16" OD.
- O-Ring fits cap on older Prochem brass chemical pumps
Brass bypass manifold body only. For older Prochem and BLUEline truck mounts.
- Brass bypass manifold
- Fits most older Prochem and Blueline truck mounts
Prochem Bypass Orifice (Blue - 0.0292) . This is used on the Prochem Legends and Prochem 405 units with Micro-Processors Catalytic and with Auto Diverter Systems.
- Stainless steel bypass orifice
- Blue - 0.0292
Idle Control Switch for TMTW$45.76